DESIGNDROP wallpapering instructions

Your wallpapering substrate must be clean, dry, absorbent and neutral in colour.
Make sure the same production number is printed on the backing.

Important note:
Switch off electrical conductors
(e.g. sockets) before processing and protect from
moisture if necessary.

Tip: Cover the floor or table with a painter's fleece before spraying the wallpaper.

Roll out your wallpaper sheet and apply enough water to the back of your wallpaper sheet using a spray bottle.

After you have sprayed the wallpaper sheet, fold the sides together and allow the water to soak in for approx. 1 minute.

Now you can attach your first sheet to the wall by placing it on top and pressing it down. Use your pressure roller for this.

Spray your wall evenly with water and place your first strip of wallpaper in the waterbed on the wall and press it on.